EasyManuals Logo

Cisco Catalyst 2960-XR Configuration Guide

Cisco Catalyst 2960-XR
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
Configuring the Forwarding-Delay Time for a VLAN
This procedure is optional.
Beginning in privileged EXEC mode, follow these steps to configure the forwarding delay time for a VLAN:
SUMMARY STEPS
1.
configure terminal
2.
spanning-tree vlan vlan-id forward-time seconds
3.
end
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Configures the forward time of a VLAN. The forwarding delay is the
number of seconds an interface waits before changing from its
spanning-tree learning and listening states to the forwarding state.
spanning-tree vlan vlan-id forward-time
seconds
Example:
Switch(config)# spanning-tree vlan
20,25 forward-time 18
Step 2
For vlan-id, you can specify a single VLAN identified by VLAN
ID number, a range of VLANs separated by a hyphen, or a series
of VLANs separated by a comma. The range is 1 to 4094.
For seconds, the range is 4 to 30; the default is 15.
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 3
Configuring the Maximum-Aging Time for a VLAN
This procedure is optional.
Beginning in privileged EXEC mode, follow these steps to configure the maximum-aging time for a VLAN:
Catalyst 2960-XR Switch Layer 2 Configuration Guide, Cisco IOS Release 15.0(2)EX1
36 OL-29424-01
Configuring Spanning Tree Protocol
Configuring the Forwarding-Delay Time for a VLAN

Table of Contents

Other manuals for Cisco Catalyst 2960-XR

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2960-XR and is the answer not in the manual?

Cisco Catalyst 2960-XR Specifications

General IconGeneral
Stacking Bandwidth80 Gbps
Layer SupportLayer 2 and Layer 3
Jumbo Frame Support9198 bytes
RAM512 MB
Input Voltage100-240V AC
ModelCatalyst 2960-XR
Uplink Interfaces4 x 1G SFP or 2 x 10G SFP+
Downlink Interfaces24 or 48 x Gigabit Ethernet ports
Power SupplyInternal
MAC Address Table Size16, 000 entries
PoEAvailable on PoE models
Weight4.5 kg
Featuresenergy efficiency
StackingUp to 8 switches
Operating Temperature0 to 45°C

Related product manuals