PurposeCommand or Action
the auto or desirable mode. If you do not specify non-silent, silent is assumed.
The silent setting is for connections to file servers or packet analyzers. This
setting allows PAgP to operate, to attach the port to a channel group, and to
use the port for transmission.
• active—Enables LACP only if a LACP device is detected. It places the port
into an active negotiating state in which the port starts negotiations with other
ports by sending LACP packets.
• passive —Enables LACP on the port and places it into a passive negotiating
state in which the port responds to LACP packets that it receives, but does not
start LACP packet negotiation.
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 6
Related Topics
Channel Groups and Port-Channel Interfaces, on page 109
PAgP Modes , on page 111
Silent Mode, on page 112
EtherChannel Configuration Guidelines, on page 120
Default EtherChannel Configuration, on page 119
Layer 2 EtherChannel Configuration Guidelines, on page 122
Configuring EtherChannel Load-Balancing
You can configure EtherChannel load-balancing by using source-based or destination-based forwarding
methods.
This task is optional.
SUMMARY STEPS
1.
configure terminal
2.
port-channel load-balance { dst-ip | dst-mac | src-dst-ip | src-dst-mac | src-ip | src-mac }
3.
end
Catalyst 2960-XR Switch Layer 2 Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29424-01 129
Configuring EtherChannels
Configuring EtherChannel Load-Balancing
To Next Page
Loading...
Need help?
General
