Cisco Catalyst 4500 Series Installation Guide

B-1
Catalyst 4500 Series Switches Installation Guide
78-14409-08
APPENDIX
B
Repacking a Switch
If you need to return your Catalyst 4500 series switch to the factory, use the
instructions in this appendix to repack your switch in preparation for shipping.
To repack the switch using the original packaging material, follow these steps:
Step 1 Slide the pieces of the packing foam over the Catalyst 4500 series switch. (See
Figure B-1.)
Step 2 Place the documentation and accessory kit in the box or poly bag provided.
Step 3 Place the box or poly bag containing the documentation and accessory kit on top
of the packing material.
Step 4 Place the switch (with packing foam pieces) into the packing carton.
Step 5 Fold in the top flaps of the packing carton and seal with packing tape.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E