Cisco Catalyst 4500 Series Installation Guide

CHAPTER
3-1
Catalyst 4500 Series Switches Installation Guide
78-14409-08
3
Installing the Switch in a Rack
Warning This unit is intended for installation in restricted access areas. A restricted
access area can be accessed only through the use of a special tool, lock and
key, or other means of security. Statement 1017
Warning Only trained and qualified personnel should be allowed to install, replace, or
service this equipment. Statement 1030
Warning To prevent personal injury or damage to the chassis, never attempt to lift or tilt
the chassis using the handles on modules (such as power supplies, fans, or
cards); these types of handles are not designed to support the weight of the unit.
Statement 1032

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E