Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine - Page 32

1-8
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 1 Cisco Secure ACS Solution Engine Overview
ACS SE Hardware Description
The Ethernet connectors are designed for attaching an unshielded twisted pair (UTP) Ethernet cable
equipped with standard RJ-45 compatible plugs. Press one end of the UTP cable into the Ethernet
connector until the plug snaps securely into place. Connect the other end of the cable to an RJ-45 port
on a hub or other device, depending on your network configuration. Observe the following cabling
restrictions for 10BASE-T, 100BASE-TX, and 1000BASE-TX networks:
• For 10BASE-T networks, use Category 3 or greater wiring and connectors.
• For 100BASE-TX and 1000BASE-TX networks, use Category 5 or greater wiring and connectors.
• The maximum cable run length is 328 feet (ft) or 100 meters (m).