Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine User Manual

4-22
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 4 Administering Cisco Secure ACS Solution Engine
Reconfiguring Solution Engine System Parameters
Step 2 At the system prompt, type set timeout followed by a single space and the timeout period in minutes.
Step 3 Press Enter.
Result: The system sets the new timeout period.
Setting the Solution Engine System Domain
You can set the system DNS domain from the serial console. To set the ACS SE system domain:
Step 1 Log in to the ACS SE. For more information, see Logging In to the Solution Engine From a Serial
Console, page 4-2.
Step 2 At the system prompt, type set domain followed by a single space and the domain name.
Step 3 Press Enter.
Result: The system displays the confirmation message:
You should reboot appliance for the change to take effect.
Setting the Solution Engine System Hostname
Caution Performing this procedure stops and restarts all services, and will interrupt use of the ACS SE.
You can set the system hostname. To set the ACS SE system hostname:
Step 1 Log in to the ACS SE. For more information, see Logging In to the Solution Engine From a Serial
Console, page 4-2.
Step 2 At the system prompt, type set hostname followed by a single space and the hostname.
Tip You can use up to 15 letters and numbers; but no spaces.
Step 3 Press Enter.
Result: The system restarts all services, and the hostname is reset. The system then displays the
confirmation message:
You should reboot appliance for the change to take effect.
(The hostname is then reset after system reboot.)

Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Specifications

General

Brand	Cisco
Model	CSACSE-1111-K9 - Secure Access Control Server Solution Engine
Category	Software
Language	English