Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine User Manual

4-4
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 4 Administering Cisco Secure ACS Solution Engine
Basic Command Line Administration Tasks
Session Timeout (in minutes)
Last Reboot Time
Current Date & Time
Time Zone
NTP Server(s)
CPU Load (percentage)
Free Disk (amount of hard drive space available)
Free Physical Memory
Appliance IP Configuration
DHCP Enabled (Yes/No)
IP Address
Subnet Mask
Default Gateway
DNS Servers
ACS Services (running/stopped)
CSAdmin
CSAgent
CSAuth
CSDbSync
CSLog
CSMon
CSRadius
CSTacacs
Tracing Routes
If you are unfamiliar with the trace route command or want information on the command’s optional
arguments, see the Command Reference entry
tracert, page C-16.
To trace the network route that the ACS SE takes to a given destination:
Step 1 At the system prompt, type tracert, followed by zero (0) or more optional arguments, and then the IP
address of the target destination.
Step 2 Press Enter.
Result: The system displays the route tracing information followed by the message:
Trace complete
Stopping Solution Engine Services From a Serial Console
Note You typically stop solution engine services in the web interface.
You can stop any of the ACS SE services from the serial console. The ACS SE services include:
• CSAdmin
• CSAgent
• CSAuth
• CSDbSync

Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Specifications

General

Brand	Cisco
Model	CSACSE-1111-K9 - Secure Access Control Server Solution Engine
Category	Software
Language	English