Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine User Manual

3-15
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 3 Installing and Configuring Cisco Secure ACS Solution Engine 4.1
Initial Configuration
h. If network connectivity is validated in the previous two steps, at the prompt, Test network
connectivity [Yes]:
, type n or N, and then press Enter.
Tip The system continues to provide you with the opportunity to test network connectivity until you
answer no. This means that you can correct network connections or retype the IP address.
Step 16 If the settings appear correctly, at the prompt, Accept network setting [Yes]:, type y or Y, and then
press Enter.
Result: The system displays the following message on the console:
Current Date Time Setting:
Time Zone: (GMT -xx:xx) XXX Time
Date and Time: mm/dd/yyyy
NTP Server(s): NTP Synchronization Disabled.
Step 17 To set the time and date of the ACS SE, at the Change Date & Time Setting [N]: prompt, type Y, and
then press Enter.
Result: The system displays a numbered list of time zones.
Step 18 At the Enter desired time zone index (0 for more choices): prompt, type the index number of
the time zone that you want, and then press Enter.
Result: The system displays the new time zone.
Step 19 At the Synchronize with NTP server? [N]: prompt, do one of the following:
• To set the time manually, type N, and then press Enter.
• To use an NTP server for setting time, type Y, and when prompted enter the IP address of the NTP
server that you want.
Tip Only if you select to use an NTP server can you subsequently use the ntpsync command.
Result: The system displays a confirmation message reflecting your choice.
Step 20 At the Enter date [mm/dd/yyyy]: prompt, type the date in the given format, and then press Enter.
Step 21 At the Enter time [hh:mm:ss]: prompt, type the current time in the given format, and then press Enter.
Result: The system displays the following message on the console:
Initial configuration is successful. Appliance will now reboot.
The system reboots.
Verifying the Initial Configuration
To verify that you have correctly completed the ACS SE initial configuration:
Before You Begin
Establish a serial console connection to the ACS SE. For details, see Establishing a Serial Console
Connection, page 3-10.

Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Specifications

General

Brand	Cisco
Model	CSACSE-1111-K9 - Secure Access Control Server Solution Engine
Category	Software
Language	English