3-14
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 3 Installing and Configuring Cisco Secure ACS Solution Engine 4.1
Initial Configuration
For more information on the GUI administrator account, see Setting Up a GUI Administrator Account,
page 3-16.
Step 14 At the Use Static IP Address [Yes]: prompt, type Y for yes or N for No, and then press Enter.
Note To set or change the IP address of your ACS SE, it must be connected to a working Ethernet
connection.
Note A static IP address must be assigned to your ACS SE. You can set the IP address directly by
answering Y to this step and performing the substeps detailed in
Step 15. Alternatively, you may
use a DHCP address if it assigns a single IP address that does not change.
Step 15 The following prompts appear only if you set a static IP address manually. Otherwise the following
message appears:
No change to the configuration.
Accept network setting [Yes]
a. To specify the ACS SE IP address, at the IP Address [xx.xx.xx.xx]: prompt, type the IP address,
and then press Enter.
b. At the Subnet Mask [xx.xx.xx.xx]: prompt, type the subnet mask value, and then press Enter.
c. At the Default Gateway [xx.xx.xx.xx]: prompt, type the default gateway value, and then press
Enter.
d. At the DNS Servers [xx.xx.xx.xx]: prompt, type the address of any DNS servers that you intend
to use (separate each by a single space), and then press Enter.
Note If you do not intend to use a DNS server, enter the IP address of the ACS SE at the DNS
Servers [xx.xx.xx.xx]:
prompt. If you do not configure the ACS SE to use a DNS server,
you must respond to all prompts for hostname or IP address only with an IP address.
Result: The system displays the new configuration information followed by this message:
IP Address is reconfigured.
e. At the prompt, Confirm the changes? [Yes]: type Y, and then press Enter.
Result: The system displays the following message:
New ip address is set.
Default gateway is set to xx.xx.xx.xx
DNS servers are set to: xx.xx.xx.xx xx.xx.xx.xx.
f. At the prompt, Test network connectivity [Yes]:, type y or Y, and then press Enter.
Tip This step is essentially executing a ping command to ensure the connectivity of the ACS SE.
g. At the prompt, Enter hostname or IP address:, type the IP address or hostname of a device
connected to the ACS SE, and then press Enter.
Result: If successful, the system displays the ping statistics. The system displays the prompt: Test
network connectivity [Yes]:.
To Next Page
Loading...
Need help?
General