Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine User Manual

3-12
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 3 Installing and Configuring Cisco Secure ACS Solution Engine 4.1
Initial Configuration
Appliance Base Image: [version number]
CSA build [version number]: (Patch: [version number])
Status: Appliance is functioning properly
The ACS Appliance has not been configured.
Logon as “Administrator” with password “setup” to configure appliance.
Note If this information does not appear and only the login prompt appears, you must reboot the appliance
and then log in.
Step 3 At the login: prompt, type Administrator and then press Enter.
Note When you boot the system for the first time, it is not configured. You must log in as CLI administrator
to configure the system.
Result: The system displays the password: prompt.
Step 4 At the password: prompt, type setup and press Enter.
Note The password is case sensitive.
Result: The system displays the following message on the console:
Initialize Appliance.
Machine will be rebooted after initialization.
Entering Ctrl-C before setting appliance name will shutdown the appliance
Step 5 At the ACS Appliance name [deliverance1]: prompt, type the name that you intend to use for your
ACS SE, and then press Enter.
Tip The name can contain up to 15 letters and numbers, but no spaces.
Result: The system displays the following message on the console:
ACS Appliance name is set to xxx.
Step 6 At the DNS domain [ ]: prompt, type the domain name. Then press Enter.
Result: The system displays the following message on the console:
DNS name is set to xxx.com.
You need to set the administrator account name and password.
Step 7 At the Enter new account name: prompt, type the ACS SE administrator account name, and then press
Enter.
Tip There is only one ACS SE CLI administrator account at a given time. This account allows access
only through a serial cable and CLI commands. The account’s credentials can be changed. For
more information see Chapter 4, “Resetting the Solution Engine Administrator Password.”
Step 8 At the Enter new password: prompt, type the new ACS SE password and press Enter.

Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Specifications

General

Brand	Cisco
Model	CSACSE-1111-K9 - Secure Access Control Server Solution Engine
Category	Software
Language	English