Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine User Manual

4-19
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 4 Administering Cisco Secure ACS Solution Engine
Reconfiguring Solution Engine System Parameters
Note To set or change the IP address of your ACS SE, ACS SE must be connected to a working Ethernet
connection.
To reconfigure the IP address:
Step 1 Log in to the ACS SE. For more information, see Logging In to the Solution Engine From a Serial
Console, page 4-2.
Step 2 Type set ip, and then press Enter.
Step 3 At the Use Static IP Address [Y]: prompt, type Y for yes or N for No, and then press Enter.
Step 4 If you answered No to using a static IP address, the system displays a confirmation of DHCP and the
message
IP Address is reconfigured. Continue the procedure with Step 5.
If you responded Yes in the previous step to use a static IP address:
a. To specify the ACS SE IP address, at the IP Address [xx.xx.xx.xx]: prompt, type the IP address,
and then press Enter.
b. At the Subnet Mask [xx.xx.xx.xx]: prompt, type the subnet mask, and then press Enter.
c. At the Default Gateway [xx.xx.xx.xx]: prompt, type the default gateway, and then press Enter.
d. At the DNS Servers [xx.xx.xx.xx]: prompt, type the address of any DNS servers you intend to
use (separate each by a single space), and then press Enter.
Result: The system displays the new configuration information and the message:
IP Address is reconfigured.
Step 5 Review the information presented and, at the Confirm the changes? [Y]: prompt, press Enter.
Result: The ACS SE restarts. The system displays the message:
New ip address is set.
Step 6 At the prompt, Test network connectivity [Yes]:, type Y, and then press Enter.
Tip This step executes a ping command to ensure the connectivity of the ACS SE.
Step 7 At the prompt, Enter hostname or IP address:, type the IP address or hostname of a device connected
to the ACS SE and then press Enter.
Result: If successful, the system displays the ping statistics. Once again the system displays the Test
network connectivity [Yes]:
prompt.
Step 8 If network connectivity is proven okay in the previous two steps, at the prompt, Test network
connectivity [Yes]:
, type N, and then press Enter.
Tip The system will continue to provide you with the opportunity to test network connectivity until
you answer N. This procedure gives you an opportunity, if required, to correct network
connections or retype the IP address.
Result: The ACS SE restarts services, and displays the system prompt.

Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Specifications

General

Brand	Cisco
Model	CSACSE-1111-K9 - Secure Access Control Server Solution Engine
Category	Software
Language	English