4-26
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 4 Administering Cisco Secure ACS Solution Engine
Recovery Management
This operation will completely erase the hard drive. Press ‘Y’ to confirm, any other key
to cancel: __
Caution The next step erases the ACS SE hard drive. You will permanently lose all system data that you have not
backed up.
Step 5 Type Y.
Result: The ACS SE processes the new image (this may take more than 2 minutes) while displaying odd
characters and then displays the message:
The system has been reimaged successfully. Please remove this recovery CD from the drive,
then hit RETURN to restart the system:
Step 6 Remove the Recovery CD from the ACS SE.
Step 7 Press Enter to restart the ACS SE.
Result: The ACS SE reboots, performs some configurations, and reboots again. The configurations that
occur after the first reboot take a significant amount of time, during which there is no feedback, which
is normal system behavior.
Note After re-imaging the solution engine hard drive, you must once again perform initial configuration of the
ACS SE. For detailed instructions, see Configuring ACS SE, page 3-11.
To Next Page
Loading...
Need help?
General