Cisco CSR 1000v Series User Manual

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
license boot level {standard | advanced | premium}
4.
end
5.
write memory
6.
reload
7.
show license detail
8.
show platform hardware throughput level
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Router> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Activates the evaluation license on the Cisco CSR 1000v upon
the next reload.
license boot level {standard | advanced |
premium}
Step 3
Example:
You must accept the End User License Agreement (EULA) to
use the evaluation license.
In Cisco IOS XE 3.12.1S and later 3.12.xS releases, use
the standard option for the IPBase feature set, the
advanced option for the Security feature set, and the
premium option for the AX feature set.
Note
Example:
Example:
Example:
Router(config)# license boot level advanced
Exits global configuration mode.end
Example:
Router(config)# end
Step 4
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
194
Installing Cisco CSR 1000v Licenses
Activating CSL Evaluation Licenses for Cisco IOS XE 3.12S and Earlier

Cisco CSR 1000v Series Specifications

General

Model	CSR 1000v Series
Category	Network Router
Virtualization	Yes
Form Factor	Virtual Appliance
Routing Protocols	BGP, OSPF, EIGRP, RIP, IS-IS
Minimum Memory	4 GB
Minimum vCPUs	1
Cloud Platforms	Microsoft Azure
Interfaces	Virtual Interfaces
Supported Protocols	IPv4, IPv6
VPN Protocols	IPSec, DMVPN
Security	IPS
High Availability	VRRP, HSRP, GLBP
Management	NETCONF, RESTCONF, SNMP
Management Interface	CLI