Cisco CSR 1000v Series

How to Configure Call Home
How to Configure Call Home
The following sections show how you can configure Call Home using a single command:
•
Configuring Smart Call Home (Single Command), on page 232
•
Configuring and Enabling Smart Call Home, on page 233
The following sections show detailed or optional configurations:
•
Enabling and Disabling Call Home , on page 234
•
Configuring Contact Information, on page 234
•
Information About Destination Profiles, on page 236
•
Subscribing to Alert Groups, on page 241
•
Configuring General email Options, on page 246
•
Specifying Rate Limit for Sending Call Home Messages, on page 249
•
Specifying HTTP Proxy Server, on page 249
•
Enabling AAA Authorization to Run IOS Commands for Call Home Messages, on page 250
•
Configuring Syslog Throttling, on page 251
•
Configuring Call Home Data Privacy, on page 252
•
Sending Call Home Communications Manually, on page 253
Configuring Smart Call Home (Single Command)
To enable all Call Home basic configurations using a single command, perform the following steps:
SUMMARY STEPS
1.
configure terminal
2.
call-home reporting {anonymous | contact-email-addr email-address} [http-proxy {ipv4-address |
ipv6-address | name} port port-number]
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
232
Configuring Call Home for the Cisco CSR 1000v
How to Configure Call Home