Cisco CSS5 SSL K9 - Syst. CSS11500 SSL MODULE - Switch Control Module Connectors and Leds

2-11
Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-16421-01
Chapter 2 Cabling and Troubleshooting the CSS
Cabling the CSS 11503 and CSS 11506 Modules
Switch Control Module Connectors and LEDs
The Switch Control Module (SCM), model CSS5-SCM-2GE, provides master
control and is responsible for the following functions:
• System powerup and boot control
• Centralized routing table management
• System-wide connection management
• An interface to an external Network Management Station
• Disk management
• An external RS-232 interface
A CSS supports a maximum of two SCMs, one active and one passive.
The Switch Control Module contains the following connectors and slots:
• 1 RJ-45 10-Mbps half-duplex Ethernet management connector.
• 1 RJ-45 RS-232 Console connector.
• 1 RJ-45 RS-232 Diag connector (reserved for field service diagnostic use
only).