Cisco D9800 - Page 165

DescriptionURI Argument
Enable SDT reception.
Type: String
Values: "Yes", "No"
sdten
Enable PAT reception.
Type: String
Values: "Yes", "No"
paten
Dejitter Buffer Latency
Type: Integer
Values: 40 … 150
dejlat
IPI Port
Type: String
Values: "Data1", "Data2", "Data3", "Data4"
ipiport
nput Redundancy Mode
Type: String
Values: "Yes", "No"
redenb
IPI Redundancy Switch Over Direction
Type: String
Values: "Non-Revertive", "Revertive"
reddir
Direct Redundancy Switch Over Delay in milliseconds
Type: Integer
Values: 0 … 10000
reddel
Revertive Redundancy Switch Over Delay in seconds
Type: Integer
Values: 0 … 30
redrev
Add or Delete an instance of IP Input
Type: String
Values: "Add” (R/W), "Delete" (R/W), "Active" (RO), "Inactive" (RO)
cmdrow
Output Fields:
Output fields returned in GET results are the same names used for the possible arguments for this command.
POST Examples:
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
153
API Definitions
Input Configuration Command