Cisco D9800 - Page 273

DescriptionCommand Detail
POST, for example,
"https://192.168.0.1/ws/v2/service_cfg/dr/tuning?csirec=1&dnlkfreq=3.53"
POST Syntax
Setting Parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
URI Parameters (extension to the Command URL separated by /): N/A
For POST, the value for the argument seen below must be specified, but for GET, there are no values
for arguments.
Note
Table 218: URI Query/Set Arguments (possible fields and values preceded by ? and separated by &)
DescriptionURI Argument
Record index of D/R backup tuning configuration
Type: Integer
Values: 1 … 3
csirec (Key)
D/R backup tuning status
Type: String
Values: "Active", "Inactive"
rowstatus
D/R backup tuning RF input selection
Type: String
Values: "RF1", "RF2", "RF3", "RF4"
input
D/R backup tuning network id
Type: Integer
Values: 0 … 65535
netid
D/R backup tuning Frequency [GHz]
Type: Float
Values: 0.0 … 15.0
dnlkfreq
D/R backup tuning RF symbol rate
Type: Float
Values: 1.0 … 45.0
symrate
D/R backup tuning RF modulation system
Type: String
Values: "DVB-S", "DVB-S2"
mod
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
261
API Definitions
Disaster Recovery (D/R) Configuration API