TAPS registration
Tool for Auto-Registered Phones Support (TAPS) is used either for a new phone or to replace an existing
phone. To register with TAPS, pick up the handset, enter the TAPS extension that your system administrator
provides, and follow the voice prompts. You may need to enter your entire extension, including the area code.
After your phone displays a confirmation message, hang up. The phone restarts.
Handset
The following table describes how to use the handset.
Then...If you want to...
Lift it to go off-hook; replace it in the cradle to go on-hook.
The ringing line is selected automatically. Contact your system
administrator for the options to select the primary line each time.
Use the handset
Press or , then hang up the handset.
Switch to the speakerphone or
headset during a call
Press during a call or after invoking a dial tone.
Adjust the volume level for a call
Headset
You can use a wired headset with your phone. You can also use a wireless headset with the wireless headset
remote hookswitch control feature.
You can use a headset with all the controls on your phone, including and .
However, if you use a wireless headset, refer to the wireless headset documentation for instructions.
Then...If you want to...
Press .
Toggle headset mode on and off
Lift the handset.Switch to a handset
Press during a call or after invoking a dial tone.
Adjust the volume level for a call
Cisco Desktop Collaboration Experience DX600 Series User Guide, Release 10.0(1)
6 OL-28931-01
Phone features
TAPS registration
To Next Page
Loading...
Need help?
General
