•
If the conference initiator disconnects, the conference call continues until all participants hang up.
Start Meet Me conference
Participants cannot join the conference until the initiator starts the conference.
Procedure
Step 1
Obtain a Meet Me phone number from your system administrator.
Step 2
Distribute the number to participants.
Step 3
When you are ready to start the meeting, go off-hook to get a dial tone, then tap Meet Me.
Step 4
Dial the Meet Me conference number.
Participants can now join the conference by dialing the Meet Me number.
Join Meet Me conference
Procedure
Step 1
Dial the Meet Me conference number that the conference initiator provides.
Step 2
If you hear a busy tone, the conference initiator has not joined the conference. Wait a minute and then try
your call again.
Conference participants list
During a standard (ad hoc) conference, you can view a list of participants and remove participants.
Control conference with participants list
The conference participants list displays conference participants.
Procedure
Step 1
Tap Conference List.
Participants are listed in the order in which they join the conference with the most recent additions at the top.
Step 2
To remove any conference participant, highlight the participant and tap End Call.
You can remove participants only if you initiated the conference call.
Cisco Desktop Collaboration Experience DX600 Series User Guide, Release 10.0(1)
OL-28931-01 37
Calling tasks
Conference calls
To Next Page
Loading...
Need help?
General
