Cisco M10-RM - Page 11

Contents
xi
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Creating an EAP Method Profile 11-18
Applying an EAP Profile to the Fast Ethernet Interface 11-18
Applying an EAP Profile to an Uplink SSID 11-19
Matching Access Point and Client Device Authentication Types 11-19
Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection
Services
12-1
Understanding WDS 12-2
Role of the WDS Device 12-2
Role of Access Points Using the WDS Device 12-3
Understanding Fast Secure Roaming 12-3
Understanding Radio Management 12-5
Understanding Layer 3 Mobility 12-5
Understanding Wireless Intrusion Detection Services 12-6
Configuring WDS 12-7
Guidelines for WDS 12-8
Requirements for WDS 12-8
Configuration Overview 12-8
Configuring Access Points as Potential WDS Devices 12-9
CLI Configuration Example 12-13
Configuring Access Points to use the WDS Device 12-14
CLI Configuration Example 12-15
Configuring the Authentication Server to Support WDS 12-15
Configuring WDS Only Mode 12-19
Viewing WDS Information 12-20
Using Debug Messages 12-21
Configuring Fast Secure Roaming 12-21
Requirements for Fast Secure Roaming 12-21
Configuring Access Points to Support Fast Secure Roaming 12-22
CLI Configuration Example 12-24
Configuring Management Frame Protection 12-24
Management Frame Protection 12-24
Overview 12-25
Protection of Unicast Management Frames 12-25
Protection of Broadcast Management Frames 12-25
Client MFP For Access Points in Root mode 12-25
Configuring Client MFP 12-26