Contents
iv
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Using the Command-Line Interface 3-1
Cisco IOS Command Modes 3-2
Getting Help 3-3
Abbreviating Commands 3-3
Using no and default Forms of Commands 3-4
Understanding CLI Messages 3-4
Using Command History 3-4
Changing the Command History Buffer Size 3-5
Recalling Commands 3-5
Disabling the Command History Feature 3-5
Using Editing Features 3-6
Enabling and Disabling Editing Features 3-6
Editing Commands Through Keystrokes 3-6
Editing Command Lines that Wrap 3-7
Searching and Filtering Output of show and more Commands 3-8
Accessing the CLI 3-9
Opening the CLI with Telnet 3-9
Opening the CLI with Secure Shell 3-9
Configuring the Access Point for the First Time 4-1
Before You Start 4-2
Resetting the Device to Default Settings 4-2
Resetting to Default Settings Using the MODE Button 4-2
Resetting to Default Settings Using the GUI 4-2
Resetting to Default Settings Using the CLI 4-3
Obtaining and Assigning an IP Address 4-4
Default IP Address Behavior 4-4
Connecting to the 1100 Series Access Point Locally 4-5
Connecting to the 1130 Series Access Point Locally 4-6
Connecting to the 1200, 1230, 1240, and 1250 Series Access Points Locally 4-6
Connecting to the 1300 Series Access Point/Bridge Locally 4-7
Default Radio Settings 4-7
Assigning Basic Settings 4-8
Default Settings on the Express Setup Page 4-14
Configuring Basic Security Settings 4-16
To Next Page
Loading...
