Name: Cisco Room Kit EQX
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Carrier beam and lower bar parts (Box: A)

1x carrier beam (left)

1x joining bracket for carrier beam

10x

(M6x8, Hex 4 mm)

1. Assemble the lower bar and carrier beam

2x lower bar (sides)

1x lower bar (center))

1x carrier beam (right)

Before you start

When assembling the wall stand, quite often there a four

screws fixing two parts together. In those cases, we

recommend the following:

1. Enter, but not tighten, the screws in the order shown

here (zig-zag pattern).

2. Tighten the screws in the same order.

16x

(M6x12, Hex 4 mm)

1 3

4 2

8x sliding nut

Questions and Answers:

Need help?

Do you have a question about the Cisco Room Kit EQX and is the answer not in the manual?

Cisco Room Kit EQX Specifications

General