Need help?Do you have a question about the Cisco Room Kit EQX and is the answer not in the manual?
Requires professional installation due to weight and complexity.
Details on securing the stand to the wall for safe support.
Ensure the stand is level on the floor before wall mounting.
Use provided power strip, avoid extension cords.
Avoid direct sunlight and ensure screens meet temperature specs.
Lists items not included by Cisco, like screens and microphones.
Steps to assemble the lower bar and carrier beam parts.
Connects the left and right frame parts and adds vertical legs.
Prepare the beam by inserting nuts for module attachment.
Attach the main central module to the carrier beam.
Attach the left and right side modules to the carrier beam.
Securely attach all mounted modules to the carrier beam.
Details on placing the codec into its bay.
Details on placing the amplifier into its bay.
Illustrates main areas for routing cables.
Points to the full wiring diagram for detailed connections.
Explains labels used to identify cables.
Indicates where accessory cables are found.
Fasten the power strip to the back plate.
Install the power supply units into their bracket.
Connect PSUs to the power strip and amplifier.
Connect the codec's power cable to the power strip.
Connect speaker cables to the amplifier.
Physically mount the speakers onto the frame.
Prepare the lower tray with straps for cable management.
Mount the bass unit and connect its cable.
Build the fan module structure.
Mount the assembled fan module onto the frame.
Connect the fan cables to the amplifier.
Secure the antenna brackets to the frame.
Route antenna cables and connect them to the codec.
Adjust the camera's angle for optimal viewing.
Connect various cables to the camera.
Secure the camera onto its mounting bracket.
Route and connect camera cables to the main units.
Specific instructions for analog microphone connections.
Specific instructions for a single digital microphone.
Specific instructions for multiple digital microphones.
Construct the speaker grille from its parts.
Mount the assembled grille onto the main frame.
Place the decorative ring around the camera.
Construct the bottom grille from its parts.
Mount the assembled bottom grille onto the main frame.
Mount the VESA interface arms onto the screen.
Link the interface arms using the adjustable brace.
Initial placement of the screen on the VESA rail.
Adjust stoppers for precise screen alignment.
Final adjustment of the rail's vertical position.
Mount interface arms onto the right screen.
Attach the right screen to the VESA rail.
Adjust the screen's vertical position.
Adjust the screen's distance from the wall.
Organize cables and attach clips for stand covers.
Snap the stand covers into place.
General| Model | Room Kit EQX |
|---|---|
| Product Type | Video conferencing system |
| Frame Rate | Up to 60 fps |
| Operating System | Cisco RoomOS |
| Network | Ethernet |
| HDMI Output | Yes |
| USB | Yes |
| Bluetooth | Bluetooth 5.0 |
| Compatibility | Microsoft Teams |
| Mounting Options | Wall mount, tabletop |
To Next Page