Name: Cisco RV082 - Small Business VPN Router
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Cisco Small Business RV0xx Series Routers Administration Guide 37

• MTU: Set the MTU (Maximum Transmission Unit) in bytes (see the

Glossary). Unless a change is required by your ISP, Cisco recommends that

you use the default setting, Auto. To specify another value, select Manual,

and then enter the size in bytes.

• Enabled DHCP-PD: Check this box to enable the DHCPv6 client process

and enable a request for prefix delegation through the selected interface.

This option is typically used if your ISP is capable of sending LAN prefixes

via DHCPv6 option. If your ISP does not support this option, then you can

manually configure a LAN prefix by entering the LAN IPv6 address below.

Note: When DHCP-PD is enabled, the manual LAN IPv6 addressing below

will be disabled and vice versa.

• LAN IPv6 Address: This option allows you to manually enter a global IPv6

prefix that was assigned by your ISP for your LAN devices, if applicable.

Check with your ISP for more information.

Questions and Answers:

Need help?

Do you have a question about the Cisco RV082 - Small Business VPN Router and is the answer not in the manual?

Cisco RV082 - Small Business VPN Router Specifications

General