• Firmware Version (Non-active) — The firmware version of the backup image.
• Firmware MD5 Checksum (Non-active) — The checksum for the backup image.
Quick Start Configuration
To simplify the device configuration through quick navigation, the Getting Started page provides links for
performing common tasks. The Getting Started page is the default window at start-up.
Linked PageLink Name (on the Page)Category
Using the Access Point Setup
Wizard, on page 2
Setup WizardQuick Access
Adding a User, on page 22Change Account Password
Configuration Files, on page 95Backup/Restore Configuration
Firmware, on page 93Upgrade Device Firmware
Radio, on page 37Wireless SettingsAdvanced Configuration
Management, on page 23Management Setting
IPv4 Configuration, on page 9LAN Setting
Guest Access, on page 80Guest Access
Dashboard, on page 87DashboardMore Information
TCP/UDP Service, on page 4TCP/UDP Service
LED Display, on page 17View System Log
Traffic Statistics, on page 90Traffic Statistics
For additional information on the device, you can access the product support page or the Cisco Support
Community by:
•
Click Support to access the product support page.
•
Click Forums to access the Cisco Support Community page.
Window Navigation
Use the navigation buttons to move around the graphical user interface of the WAP.
Configuration Utility Header
Cisco WAP125 Wireless-AC/N Dual Band Desktop Access Point with PoE
6
Getting Started
Quick Start Configuration