Cisco WAP125 - Page 97

Client Summary
Displays the client summary by 802.11 client type currently on the device.
Average Bandwidth
Displays the average client bandwidth in Mbps.
• Upload — Throughput of the last 30 seconds transmitted.
• Download — Throughput of the last 30 seconds received.
Click Upload or Download to not display data.Note
Lowest Signal-to-Noise (SNR) Clients
List the lowest 5 devices according to SNR.
Lowest Speed Clients
List the lowest 5 devices according to speed order.
Associated Clients
• Clients Details — The MAC address of the associated wireless client.
• Network (SSID) — The Service Set Identifier (SSID) for the WAP device. The SSID is an alphanumeric
string of up to 32 characters that uniquely identifies a wireless local area network. It is also referred to
as the Network Name.
• Mode — The IEEE 802.11 mode being used on the client, such as IEEE 802.11a, IEEE 802.11b, IEEE
802.11g.
• Data Rate — The current transmitting data rate.
• Channel — The channel on which the Client is current in connection with. The channel defines the
portion of the radio spectrum that the radio uses for transmitting and receiving. You can use the Radio
page to set the channel.
• Traffic (Up /Down) — The total number of bytes sent (Up) or received (Down) by the client device.
• SNR (db) — Displays the SNR strength in decibels (dB).
• Throughput Meter — The last 30 seconds' throughput / Data Rate.
You can order the clients through Clients Details, Network (SSID), and so on.
You can filter clients the through Clients Details, Network (SSID), and so on.
Note
Cisco WAP125 Wireless-AC/N Dual Band Desktop Access Point with PoE
91
Monitor
Clients