Cisco WRP500 Administration Guide

REVIEW DRAFT #1—CISCO CONFIDENTIAL
B-18
Cisco WRP500 Administration Guide
Appendix B Data Fields
Access Restrictions
Security > VPN Passthrough
Access Restrictions
The Access Restrictions module includes the following pages:
• “Access Restrictions > Internet Access” on page 18
Access Restrictions > Internet Access
IPSec Passthrough Internet Protocol Security (IPSec) is a suite of
protocols used to implement secure exchange of
packets at the IP layer. When this feature is enabled,
IPSec tunnels are allowed to pass through the WRP500.
Default: Enabled
PPTP Passthrough Point-to-Point Tunneling Protocol (PPTP)
allows the Point-to-Point Protocol (PPP) to be tunneled
through an IP network. When this feature is enabled,
PPTP tunnels are allowed to pass through the WRP500.
Default: Enabled
L2TP Passthrough Layer 2 Tunneling Protocol is the method used to
enable Point-to-Point sessions via the Internet on the
Layer 2 level. When this feature is enabled, L2TP
tunnels are allowed to pass through the WRP500.
Default: Enabled
Enter Policy Name A name for the policy
Status Policies are disabled by default. To enable the selected
policy, select Enabled.
Applied PCs The computers that will be affected by the policy that
you selected in the Access Policy list.
• MAC Address: The MAC address of the device.
• IP Address: The final octet of the IP address.
• IP Address Range: A range of devices, identfied by
the final octet of the starting IP address and the
final octect of the ending IP address.

Cisco WRP500 Specifications

General

Brand	Cisco
Model	WRP500
Category	Wireless Router
Language	English