Cisco WRP500 Administration Guide

REVIEW DRAFT #1—CISCO CONFIDENTIAL
A-34
Cisco WRP500 Administration Guide
Appendix A Advanced Voice Fields
Line page
Voice tab > Line page >
Call Feature Settings section
Voice tab > Line page >
Proxy and Registration section
Refer Target Bye Delay
For the Refer Target Bye Delay, enter the appropriate period of time
in seconds.
The default is 0.
Referee Bye Delay
For the Referee Bye Delay, enter the appropriate period of time in
seconds.
The default is 0.
Refer-To Target
Contact
To contact the refer-to target, select yes. Otherwise, select no.
The default is no.
Sticky 183
If this feature is enabled, the IP telephony ignores further 180 SIP
responses after receiving the first 183 SIP response for an outbound
INVITE. To enable this feature, select yes. Otherwise, select no.
The default is no.
Auth INVITE
When enabled, authorization is required for initial incoming
INVITE requests from the SIP proxy.
Blind Attn-Xfer Enable Enables the WRP500 to perform an attended transfer operation by
ending the current call leg and performing a blind transfer of the other
call leg. If this feature is disabled, the WRP500 performs an attended
transfer operation by referring the other call leg to the current call leg
while maintaining both call legs. To use this feature, select yes.
Otherwise, select no.
The default is no.
Xfer When Hangup
Conf
Makes the ATA perform a transfer when a conference call has
ended. Select yes or no from the drop-down menu.
The default is yes.
Proxy
SIP proxy server for all outbound requests.
Outbound Proxy
SIP Outbound Proxy Server where all outbound requests are sent as
the first hop.

Cisco WRP500 Specifications

General

Brand	Cisco
Model	WRP500
Category	Wireless Router
Language	English