REVIEW DRAFT #1—CISCO CONFIDENTIAL
A-14
Cisco WRP500 Administration Guide
Appendix A Advanced Voice Fields
Regional page
Voice tab > Regional page >
Call Progress Tones section
Dial Tone Prompts the user to enter a phone number. Reorder Tone is played
automatically when Dial Tone or any of its alternatives times out.
The default is 350@-19,440@-19;10(*/0/1+2).
Second Dial Tone Alternative to the Dial Tone when the user dials a three-way call.
The default is 420@-19,520@-19;10(*/0/1+2).
Outside Dial Tone Alternative to the Dial Tone. It prompts the user to enter an external
phone number, as opposed to an internal extension. It is triggered by
a, (comma) character encountered in the dial plan.
The default is 420@-19;10(*/0/1).
Prompt Tone Prompts the user to enter a call forwarding phone number.
The default is 520@-19,620@-19;10(*/0/1+2).
Busy Tone Played when a 486 RSC is received for an outbound call.
The default is 480@-19,620@-19;10(.5/.5/1+2).
Reorder Tone Played when an outbound call has failed or after the far end hangs
up during an established call. Reorder Tone is played automatically
when Dial Tone or any of its alternatives times out.
The default is 480@-19,620@-19;10(.25/.25/1+2).
Off Hook Warning
Tone
Played when the caller has not properly placed the handset on the
cradle. Off Hook Warning Tone is played when Reorder Tone times
out.
The default is 480@10,620@0;10(.125/.125/1+2).
Ring Back Tone Played during an outbound call when the far end is ringing.
The default is 440@-19,480@-19;*(2/4/1+2).
Ring Back 2 Tone Your WRP500 plays this ringback tone instead of Ring Back Tone if
the called party replies with a SIP 182 response without SDP to its
outbound INVITE request. The default value is the same as Ring
Back Tone, except the cadence is 1s on and 1s off.
The default is 440@-19,480@-19;*(1/1/1+2).
Confirm Tone Brief tone to notify the user that the last input value has been
accepted.
The default is 600@-16; 1(.25/.25/1).