Cisco WRP500 Administration Guide

REVIEW DRAFT #1—CISCO CONFIDENTIAL
A-6
Cisco WRP500 Administration Guide
Appendix A Advanced Voice Fields
SIP page
SIP page
You can use the Vo i c e ta b > S IP page to configure the SIP settings. This page includes the following
sections:
• “SIP Parameters section” section on page A-6
• “SIP Timer Values (sec) section” section on page A-8
• “Response Status Code Handling section” section on page A-9
• “RTP Parameters section” section on page A-10
• “SDP Payload Types section” section on page A-10
• “NAT Support Parameters section” section on page A-11
Voice tab > SIP page >
SIP Parameters section
Max Forward SIP Max Forward value, which can range from 1 to 255.
The default is 70.
Max Redirection Number of times an invite can be redirected to avoid an infinite
loop.
The default is 5.
Max Auth Maximum number of times (from 0 to 255) a request may be
challenged.
The default is 2.
SIP User Agent Name User-Agent header used in outbound requests.
The default is $VERSION. If empty, the header is not included.
Macro expansion of $A to $D corresponding to GPP_A to GPP_D
allowed.
SIP Server Name Server header used in responses to inbound responses.
The default is $VERSION.
SIP Reg User Agent
Name
User-Agent name to be used in a REGISTER request. If this value
is not specified, the SIP User Agent Name parameter is also used for
the REGISTER request.
The default is blank.
SIP Accept Language Accept-Language header used. There is no default (this indicates
the WRP500 does not include this header). If empty, the header is
not included.

Cisco WRP500 Specifications

General

Brand	Cisco
Model	WRP500
Category	Wireless Router
Language	English