REVIEW DRAFT #1—CISCO CONFIDENTIAL
A-41
Cisco WRP500 Administration Guide
Appendix A Advanced Voice Fields
User page
Voice tab > Line page >
FXS Port Polarity Configuration section
User page
You can use this page to configure the user settings. This page includes the following sections:
• “Call Forward Settings section” section on page A-42
• “Selective Call Forward Settings section” section on page A-42
• “Speed Dial Settings section” section on page A-43
• “Supplementary Service Settings section” section on page A-43
• “Distinctive Ring Settings section” section on page A-45
Enable IP Dialing Enable or disable IP dialing.
If IP dialing is enabled, one can dial [user-id@]a.b.c.d[:port], where
‘@’, ‘.’, and ‘:’ are dialed by entering *, user-id must be numeric
(like a phone number) and a, b, c, d must be between 0 and 255, and
port must be larger than 255. If port is not given, 5060 is used. Port
and User-Id are optional. If the user-id portion matches a pattern in
the dial plan, then it is interpreted as a regular phone number
according to the dial plan. The INVITE message, however, is still
sent to the outbound proxy if it is enabled.
The default is no.
Emergency Number Comma separated list of emergency number patterns. If outbound call
matches one of the pattern, the WRP500 will disable hook flash event
handling. The condition is restored to normal after the phone is on-hook.
Blank signifies no emergency number. Maximum number length is 63
characters.
The default is blank.
Idle Polarity Polarity before a call is connected: Forward or Reverse.
The default is Forward.
Caller Conn Polarity Polarity after an outbound call is connected: Forward or Reverse.
The default is Forward.
Callee Conn Polarity Polarity after an inbound call is connected: Forward or Reverse.
The default is Forward.
To Next Page
Loading...
Need help?
General
