REVIEW DRAFT #1—CISCO CONFIDENTIAL
A-43
Cisco WRP500 Administration Guide
Appendix A Advanced Voice Fields
User page
Voice tab > User page >
Speed Dial Settings section
This section does not apply to the WIP310 wireless phone.
Voice tab > User page >
Supplementary Service Settings section
The WRP500 provides native support of a large set of enhanced or supplementary services. All of
these services are optional. The parameters listed in the following table are used to enable or
disable a specific supplementary service. A supplementary service should be disabled if a) the user
has not subscribed for it, or b) the Service Provider intends to support similar service using other
means than relying on the WRP500.
Accept Last Caller ID of caller accepted via the Accept Last Caller service.
The default is blank.
Cfwd Last Caller The Caller number that is actively forwarded to Cfwd Last Dest by
using the Call Forward Last activation code
The default is blank.
Cfwd Last Dest Forward number for the Cfwd Last Caller parameter.
Same as Cfwd All Dest.
The default is blank.
Speed Dial 2-9 Target phone number (or URL) assigned to speed dial 2, 3, 4, 5, 6,
7, 8, or 9.
The default is blank.
CW Setting Call Waiting on/off for all calls.
The default is yes.
Block CID Setting Block Caller ID on/off for all calls.
The default is no.
Block ANC Setting Block Anonymous Calls on or off.
The default is no.
To Next Page
Loading...
Need help?
General
