Cisco WRP500 Administration Guide

REVIEW DRAFT #1—CISCO CONFIDENTIAL
B-9
Cisco WRP500 Administration Guide
Appendix B Data Fields
Setup
Setup > Mobile Network
Static Routing Pre-determined pathways that network information travels
to reach a specific host or network.
• Route Name: A name for the route, including up to
25 alphanumeric characters.
• Destination LAN IP: The address of the remote
network or host to which you want to assign a static
route.
• Subnet Mask: The subnet mask for the destination
network.
• Gateway: The IP address of the gateway device that
allows for contact between the WRP500 and the
remote network or host.
• Interface: The location of the destination network,
LAN and Wireless (Ethernet and wireless
networks) or the Internet (WAN).
Connect Mode
• Auto: When this mode is selected, the modem can
establish a connection automatically.
• Manual: When this mode is selected, a connection
is established manually.
Connect on Demand When this feature is enabled, the modem can
automatically re-establish a terminated connection
when a user attempts to access the Internet again.
Max. Idle Time The number of minutes of inactivity that can elapse
before an Internet connection is terminated.
Default: 5 minutes
Keep Alive When this feature is enabled, the WRP500 periodically
checks the Internet connection. If the connection is
terminated, then the WRP500 automatically
re-establishes the connection.
Card Status The current modem connection status as Detecting,
Connecting, or Connected.
Configure Mode
• Auto: When this mode is enabled, the WRP500
automatically detects which card model was
inserted and which carrier is available.
• Manual: When this mode is enabled, the connection
is established manually.

Cisco WRP500 Specifications

General

Brand	Cisco
Model	WRP500
Category	Wireless Router
Language	English