REVIEW DRAFT #1—CISCO CONFIDENTIAL
3-17
Cisco WRP500 Administration Guide
Chapter 3 Configure Voice Services
Configure Dial Plans
9,8,1[2-9]xxxxxxxxxS0 With the timer set to 0, the call is transmitted automatically when the user
dials the final digit in the sequence.
Edit Dial Plans
You can edit dial plans and can modify the control timers.
Enter the Line Interface Dial Plan
This dial plan is used to strip steering digits from a dialed number before it is transmitted out to the
carrier.
Step 1 Start Internet Explorer, connect to the Configuration Utility, choose Voice > Admin Login. If prompted,
enter the administrative login provided by the Service Provider. (The default username and password are
both admin.)rovided by your Service Provider.
Step 2 Under the Voice menu, click Line 1 or Line 2, depending on the line interface that you want to configure.
Step 3 Scroll down to the Dial Plan section.
Step 4 Enter the digit sequences in the Dial Plan field. For more information, see “About Dial Plans,” on
page 11.
Step 5 Click Submit.
Reset the Control Timers
You can use the following procedure to reset the default timer settings for all calls.
Note If you need to edit a timer setting only for a particular digit sequence or type of call, you can edit the
dial plan. See “About Dial Plans,” on page 11.
Step 1 Start Internet Explorer, connect to the Configuration Utility, choose Voice > Admin Login. If prompted,
enter the administrative login provided by the Service Provider. (The default username and password are
both admin.)rovided by your Service Provider.
Step 2 Under the Voice menu, click Regional.
Step 3 Scroll down to the Control Timer Values section.
Step 4 Enter the desired values in the Interdigit Long Timer field and the Interdigit Short Timer field. Refer to
the definitions at the beginning of this section.
To Next Page
Loading...
Need help?
General
