Cisco WRP500

REVIEW DRAFT #1—CISCO CONFIDENTIAL
A-15
Cisco WRP500 Administration Guide
Appendix A Advanced Voice Fields
Regional page
SIT1 Tone Alternative to the Reorder Tone played when an error occurs as a
caller makes an outbound call. The RSC to trigger this tone is
configurable on the SIP screen.
The default is
985@-16,1428@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0
).
SIT2 Tone Alternative to the Reorder Tone played when an error occurs as a
caller makes an outbound call. The RSC to trigger this tone is
configurable on the SIP screen.
The default is
914@-16,1371@-16,1777@-16;20(.274/0/1,.274/0/2,.380/0/3,0/4/0
).
SIT3 Tone Alternative to the Reorder Tone played when an error occurs as a
caller makes an outbound call. The RSC to trigger this tone is
configurable on the SIP screen.
The default is
914@-16,1371@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0
).
SIT4 Tone Alternative to the Reorder Tone played when an error occurs as a
caller makes an outbound call. The RSC to trigger this tone is
configurable on the SIP screen.
The default is
985@-16,1371@-16,1777@-16;20(.380/0/1,.274/0/2,.380/0/3,0/4/0
).
MWI Dial Tone Played instead of the Dial Tone when there are unheard messages in
the caller’s mailbox.
The default is 350@-19,440@-19;2(.1/.1/1+2);10(*/0/1+2).
Cfwd Dial Tone Played when all calls are forwarded.
The default is 350@-19,440@-19;2(.2/.2/1+2);10(*/0/1+2).
Holding Tone Informs the local caller that the far end has placed the call on hold.
The default is 600@-19*(.1/.1/1,.1/.1/1,.1/9.5/1).
Conference Tone Played to all parties when a three-way conference call is in
progress.
The default is 350@-19;20(.1/.1/1,.1/9.7/1).