EasyManuals Logo

Cisco WRP500 Administration Guide

Cisco WRP500
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
REVIEW DRAFT #1—CISCO CONFIDENTIAL
1-8
Cisco WRP500 Administration Guide
Chapter 1 Product Overview and Deployment Guidelines
Special Requirements for Voice Deployments
example, in the case of a 2 Mbps uplink broadband connection, assume 1 Mbps. Limit the
uplink bandwidth in the Integrated Access Device to this value. This setting helps to maintain
the utilization levels below 60%, thus reducing jitter and packet loss.
Use an additional broadband connection for voice services only. A separate connection is
required when the broadband connection services do not offer quality of service and when it is
not possible to apply the above mentioned utilization mechanism.
The available connection bandwidth determines the maximum number of simultaneous calls that the
system can support with the appropriate audio quality. Use this information to determine the maximum
number of simultaneous VoIP connections that the system can support.
For asymmetric connections, such as ADSL, the maximum number of calls is determined by the
upstream bandwidth. In general it is a good practice to use no more than 75% of the total available
bandwidth for calls. This provides space for data traffic and helps ensure good voice quality.
Note Some ITSP SIP trunk services limit the maximum number of simultaneous calls. Please check with your
Service Provider to understand the maximum number of simultaneous calls each SIP trunk supports.
The following table provides the approximate bandwidth budget for different codecs.
Note The Cisco WRP500 supports only the G.711 and G.729 codecs.
For more information about bandwidth calculation, refer to the following web sites:
www.erlang.com/calculator/lipb/
www.bandcalc.com/
Codec Approximate bandwidth
budget for each side of
conversation
2 calls 4 calls 6 calls 8 calls
G.711 110 kbps 220 kbps 440 kbps 660 kbps 880 kbps
G.726-4
0
87 kbps 174 kbps 348 kbps 522 kbps 696 kbps
G.726-3
2
79 kbps 158 kbps 316 kbps 474 kbps 632 kbps
G.726-2
4
71 kbps 142 kbps 284 kbps 426 kbps 568 kbps
G.726-1
6
63 kbps 126 kbps 252 kbps 378 kbps 504 kbps
G.729 55 kbps 110 kbps 220 kbps 330 kbps 440 kbps

Table of Contents

Other manuals for Cisco WRP500

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco WRP500 and is the answer not in the manual?

Cisco WRP500 Specifications

General IconGeneral
BrandCisco
ModelWRP500
CategoryWireless Router
LanguageEnglish

Related product manuals