REVIEW DRAFT #1—CISCO CONFIDENTIAL
B-6
Cisco WRP500 Administration Guide
Appendix B Data Fields
Setup
MTU Size When Manual is selected in the MTU field, this option is
enabled. Set this value in the 576 to 1500 range. The
default size depends on the Internet Connection Type:
• DHCP or Static IP: 1500
• PPPoE: 1492
• PPTP or L2TP: 460
• Telstra Cable: 1500
Static DNS 1, 2, 3 The Domain Name System (DNS) is how the Internet
translates domain or website names into Internet addresses
or URLs. Enter the IP address of the DNS server, which is
provided by your service provider. If you wish to use a
different DNS server, enter its IP address in one of these
fields. You can enter up to three DNS server IP addresses
here. The WRP500 will use these for quicker access to
functioning DNS servers. By default, the WRP500 uses
192.168.15.1 for DNS.
Network Setup
Local IP Address The address of the WRP500 on the local area network.
Subnet Mask The subnet mask for the local area network.
DHCP Server When this feature is enabled, the WRP500 assigns IP
addresses dynamically to the connected devices.
Default:: Enabled
DHCP Reservation You can use this feature to reserve IP addresses for use by
specified devices on your network.
DNS Proxy The DNS proxy relays DNS requests to the current public
network DNS server for the proxy, and it replies as a DNS
resolver to the client device on the network.
Default: Disabled
Starting IP Address The first IP address in the range of addresses that the
DHCP server issues to connected devices. The Starting IP
Address must be greater than the default IP address of the
WRP500, 192.168.15.1, and less than 192.168.15.253.
Default: 192.168.15.100
Maximum DHCP Users The maximum number of computers that will receive IP
addresses from the DHCP server. This number cannot be
greater than 253.
Default: 50
IP Address Range The range of available IP addresses
To Next Page
Loading...
Need help?
General
