CHAPTER
9-1
Catalyst 3560 Switch Software Configuration Guide
78-16156-01
9
Configuring 802.1X Port-Based Authentication
This chapter describes how to configure IEEE 802.1X port-based authentication on the Catalyst 3560
switch. As LANs extend to hotels, airports, and corporate lobbies, creating insecure environments,
802.1X prevents unauthorized devices (clients) from gaining access to the network.
Note For complete syntax and usage information for the commands used in this chapter, refer to the command
reference for this release.
This chapter consists of these sections:
• Understanding 802.1X Port-Based Authentication, page 9-1
• Configuring 802.1X Authentication, page 9-9
• Displaying 802.1X Statistics and Status, page 9-19
Understanding 802.1X Port-Based Authentication
The IEEE 802.1X standard defines a client-server-based access control and authentication protocol that
restricts unauthorized clients from connecting to a LAN through publicly accessible ports. The
authentication server authenticates each client connected to a switch port before making available any
services offered by the switch or the LAN.
Until the client is authenticated, 802.1X access control allows only Extensible Authentication Protocol
over LAN (EAPOL), Cisco Discovery Protocol (CDP), and Spanning Tree Protocol (STP) traffic through
the port to which the client is connected. After authentication is successful, normal traffic can pass
through the port.
These sections describe 802.1X port-based authentication:
• Device Roles, page 9-2
• Authentication Initiation and Message Exchange, page 9-3
• Ports in Authorized and Unauthorized States, page 9-4
• Supported Topologies, page 9-4
• Using 802.1X with Port Security, page 9-5
• Using 802.1X with Voice VLAN Ports, page 9-6
• Using 802.1X with VLAN Assignment, page 9-6
• Using 802.1X with Guest VLAN, page 9-8
• Using 802.1X with Per-User ACLs, page 9-8
To Next Page
Loading...
Need help?
General