EasyManuals Logo

Cisco WS-C3560-48PS-S User Manual

Cisco WS-C3560-48PS-S
892 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #274 background imageLoading...
Page #274 background image
12-30
Catalyst 3560 Switch Software Configuration Guide
78-16156-01
Chapter 12 Configuring VLANs
Configuring VMPS
Entering the IP Address of the VMPS
You must first enter the IP address of the server to configure the switch as a client.
Note If the VMPS is being defined for a cluster of switches, enter the address on the command switch.
Beginning in privileged EXEC mode, follow these steps to enter the IP address of the VMPS:
Note You must have IP connectivity to the VMPS for dynamic-access ports to work. You can test for IP
connectivity by pinging the IP address of the VMPS and verifying that you get a response.
Configuring Dynamic-Access Ports on VMPS Clients
If you are configuring a port on a cluster member switch as a dynamic-access port, first use the
rcommand privileged EXEC command to log into the cluster member switch.
Caution Dynamic-access port VLAN membership is for end stations or hubs connected to end stations.
Connecting dynamic-access ports to other switches can cause a loss of connectivity.
Beginning in privileged EXEC mode, follow these steps to configure a dynamic-access port on a VMPS
client switch:
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
vmps server ipaddress primary Enter the IP address of the switch acting as the primary VMPS server.
Step 3
vmps server ipaddress (Optional) Enter the IP address of the switch acting as a secondary VMPS
server.
You can enter up to three secondary server addresses.
Step 4
end Return to privileged EXEC mode.
Step 5
show vmps Verify your entries in the VMPS Domain Server field of the display.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Enter interface configuration mode for the switch port that is
connected to the end station.
Step 3
switchport mode access Set the port to access mode.
Step 4
switchport access vlan dynamic Configure the port as eligible for dynamic VLAN membership.
The dynamic-access port must be connected to an end station.
Step 5
end Return to privileged EXEC mode.

Table of Contents

Other manuals for Cisco WS-C3560-48PS-S

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco WS-C3560-48PS-S and is the answer not in the manual?

Cisco WS-C3560-48PS-S Specifications

General IconGeneral
BrandCisco
ModelWS-C3560-48PS-S
CategorySwitch
LanguageEnglish

Related product manuals