CHAPTER
30-1
Catalyst 3560 Switch Software Configuration Guide
78-16156-01
30
Configuring IP Unicast Routing
This chapter describes how to configure IP unicast routing on the Catalyst 3560 switch. Basic routing
functions, including static routing and the Routing Information Protocol (RIP), are available with both
the standard multilayer software image (SMI) and the enhanced multilayer image (EMI). To use
advanced routing features and other routing protocols, you must have the enhanced multilayer image
installed on the switch.
Note For more detailed IP unicast configuration information, refer to the Cisco IOS IP and IP Routing
Configuration Guide for Release 12.1. For complete syntax and usage information for the commands
used in this chapter, refer to the Cisco IOS IP and IP Routing Command Reference for Release 12.1.
This chapter consists of these sections:
• Understanding IP Routing, page 30-2
• Steps for Configuring Routing, page 30-3
• Configuring IP Addressing, page 30-4
• Enabling IP Unicast Routing, page 30-18
• Configuring RIP, page 30-19
• Configuring IGRP, page 30-23
• Configuring OSPF, page 30-28
• Configuring EIGRP, page 30-37
• Configuring BGP, page 30-43
• Configuring Protocol-Independent Features, page 30-63
• Monitoring and Maintaining the IP Network, page 30-77
Note When configuring routing parameters on the switch and to allocate system resources to maximize the
number of unicast routes allowed, you can use the sdm prefer routing global configuration command
to set the Switch Database Management (sdm) feature to the routing template. For more information on
the SDM templates, see Chapter 7, “Configuring SDM Templates” or refer to the sdm prefer command
in the command reference for this release.
To Next Page
Loading...
Need help?
General