EasyManuals Logo

Cisco WS-C3560-48PS-S User Manual

Cisco WS-C3560-48PS-S
892 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #293 background imageLoading...
Page #293 background image
13-15
Catalyst 3560 Switch Software Configuration Guide
78-16156-01
Chapter 13 Configuring VTP
Monitoring VTP
You can also change the VTP domain name by entering the vlan database privileged EXEC command
to enter VLAN database configuration mode and by entering the vtp domain domain-name command.
In this mode, you must enter the exit command to update VLAN information and return to privileged
EXEC mode.
After resetting the configuration revision number, add the switch to the VTP domain.
Note You can use the vtp mode transparent global configuration command or the vtp transparent VLAN
database configuration command to disable VTP on the switch, and then change its VLAN information
without affecting the other switches in the VTP domain.
Monitoring VTP
You monitor VTP by displaying VTP configuration information: the domain name, the current VTP
revision, and the number of VLANs. You can also display statistics about the advertisements sent and
received by the switch.
Table 13-3 shows the privileged EXEC commands for monitoring VTP activity.
Step 3
vtp domain domain-name Change the domain name from the original one displayed in Step 1 to a new name.
Step 4
end The VLAN information on the switch is updated and the configuration revision
number is reset to 0. You return to privileged EXEC mode.
Step 5
show vtp status Verify that the configuration revision number has been reset to 0.
Step 6
configure terminal Enter global configuration mode.
Step 7
vtp domain domain-name Enter the original domain name on the switch.
Step 8
end The VLAN information on the switch is updated, and you return to privileged EXEC
mode.
Step 9
show vtp status (Optional) Verify that the domain name is the same as in Step 1 and that the
configuration revision number is 0.
Command Purpose
Table 13-3 VTP Monitoring Commands
Command Purpose
show vtp status Display the VTP switch configuration information.
show vtp counters Display counters about VTP messages that have been sent and received.

Table of Contents

Other manuals for Cisco WS-C3560-48PS-S

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco WS-C3560-48PS-S and is the answer not in the manual?

Cisco WS-C3560-48PS-S Specifications

General IconGeneral
BrandCisco
ModelWS-C3560-48PS-S
CategorySwitch
LanguageEnglish

Related product manuals