CHAPTER
11-1
Catalyst 3560 Switch Software Configuration Guide
78-16156-01
11
Configuring SmartPort Macros
This chapter describes how to configure and apply SmartPort macros on the Catalyst 3560 switch.
Note For complete syntax and usage information for the commands used in this chapter, refer to the command
reference for this release.
This chapter consists of these sections:
• Understanding SmartPort Macros, page 11-1
• Configuring Smart-Port Macros, page 11-2
• Displaying SmartPort Macros, page 11-4
Understanding SmartPort Macros
SmartPort macros provide a convenient way to save and share common configurations. You can use
SmartPort macros to enable features and settings based on the location of a switch in the network and
for mass configuration deployments across the network.
Each SmartPort macro is a set of CLI commands that you define. SmartPort macros do not contain new
CLI commands; they are simply a group of existing CLI commands.
When you apply a SmartPort macro on an interface, the CLI commands within the macro are configured
on the interface. When the macro is applied to an interface, the existing interface configurations are not
lost. The new commands are added to the interface and are saved in the running configuration file.
To Next Page
Loading...
Need help?
General