25-2
Catalyst 3560 Switch Software Configuration Guide
78-16156-01
Chapter 25 Configuring System Message Logging
Configuring System Message Logging
Configuring System Message Logging
These sections describe how to configure system message logging:
• System Log Message Format, page 25-2
• Default System Message Logging Configuration, page 25-3
• Disabling Message Logging, page 25-4 (optional)
• Setting the Message Display Destination Device, page 25-4 (optional)
• Synchronizing Log Messages, page 25-5 (optional)
• Enabling and Disabling Time Stamps on Log Messages, page 25-7 (optional)
• Enabling and Disabling Sequence Numbers in Log Messages, page 25-7 (optional)
• Defining the Message Severity Level, page 25-8 (optional)
• Limiting Syslog Messages Sent to the History Table and to SNMP, page 25-9 (optional)
• Configuring UNIX Syslog Servers, page 25-10 (optional)
System Log Message Format
System log messages can contain up to 80 characters and a percent sign (%), which follows the optional
sequence number or time-stamp information, if configured. Messages appear in this format:
seq no:timestamp: %facility-severity-MNEMONIC:description
The part of the message preceding the percent sign depends on the setting of the service
sequence-numbers, service timestamps log datetime, service timestamps log datetime [localtime]
[msec] [show-timezone], or service timestamps log uptime global configuration command.
Table 25-1 describes the elements of syslog messages.
Table 25-1 System Log Message Elements
Element Description
seq no: Stamps log messages with a sequence number only if the service sequence-numbers global
configuration command is configured.
For more information, see the “Enabling and Disabling Sequence Numbers in Log Messages”
section on page 25-7.
timestamp formats:
mm/dd hh:mm:ss
or
hh:mm:ss (short uptime)
or
d h (long uptime)
Date and time of the message or event. This information appears only if the service timestamps
log [datetime | log] global configuration command is configured.
For more information, see the “Enabling and Disabling Time Stamps on Log Messages” section
on page 25-7.
facility The facility to which the message refers (for example, SNMP, SYS, and so forth). For a list of
supported facilities, see Table 25-4 on page 25-12.
severity Single-digit code from 0 to 7 that is the severity of the message. For a description of the severity
levels, see Table 25-3 on page 25-9.
To Next Page
Loading...
Need help?
General