Cisco WS-C3560-48PS-S User Manual

1-9
Catalyst 3560 Switch Software Configuration Guide
78-16156-01
Chapter 1 Overview
Default Settings After Initial Switch Configuration
Monitoring Features
• Switch LEDs that provide port- and switch-level status
• MAC address notification traps and RADIUS accounting for tracking users on a network by storing
the MAC addresses that the switch has learned or removed
• Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN) for traffic monitoring on any port or
VLAN
• SPAN and RSPAN support of Intrusion Detection Systems (IDS) to monitor, repel, and report
network security violations
• Four groups (history, statistics, alarms, and events) of embedded RMON agents for network
monitoring and traffic analysis
• Syslog facility for logging system messages about authentication or authorization errors, resource
issues, and time-out events
• Layer 2 traceroute to identify the physical path that a packet takes from a source device to a
destination device
Default Settings After Initial Switch Configuration
The switch is designed for plug-and-play operation, requiring only that you assign basic IP information
to the switch and connect it to the other devices in your network. If you have specific network needs,
you can change the interface-specific and system-wide settings.
If you do not configure the switch at all, the switch operates with the default settings listed in Table 1-1.
This table lists the key software features, their defaults, and where to find more information about the
features.
For information about setting up the initial switch configuration (using Express Setup or the CLI setup
program) and assigning basic IP information to the switch, refer to the hardware installation guide.
Table 1-1 Default Settings After Initial Switch Configuration
Feature Default Setting More information in...
Switch IP address, subnet mask, and
default gateway
0.0.0.0 Chapter 4, “Assigning the Switch IP
Address and Default Gateway”
Domain name None
DHCP DHCP client enabled
Switch cluster Disabled Chapter 5, “Clustering Switches”
Passwords None defined Chapter 6, “Administering the Switch”
TACACS+ Disabled
RADIUS Disabled
System name and prompt Switch
NTP Enabled
DNS Enabled
802.1X Disabled Chapter 9, “Configuring 802.1X
Port-Based Authentication”

Cisco WS-C3560-48PS-S Specifications

General

Brand	Cisco
Model	WS-C3560-48PS-S
Category	Switch
Language	English