1-10
Catalyst 3560 Switch Software Configuration Guide
78-16156-01
Chapter 1 Overview
Default Settings After Initial Switch Configuration
Port parameters
Operating mode Layer 2 (switchport) Chapter 10, “Configuring Interface
Characteristics”
Interface speed and duplex mode Autonegotiate
Auto-MDIX Disabled
Flow control Off
Power over Ethernet (PoE) Auto
SmartPort macros None defined Chapter 11, “Configuring SmartPort
Macros”
VLANs
Default VLAN VLAN 1 Chapter 12, “Configuring VLANs”
VLAN trunking Dynamic auto (DTP)
Trunk encapsulation Negotiate
VTP mode Server Chapter 13, “Configuring VTP”
VTP version 1
Voice VLAN Disabled Chapter 14, “Configuring Voice VLAN”
STP PVST+ enabled on VLAN 1 Chapter 15, “Configuring STP”
MSTP Disabled Chapter 16, “Configuring MSTP”
Optional spanning-tree features Disabled Chapter 17, “Configuring Optional
Spanning-Tree Features”
DHCP snooping
DHCP snooping Disabled Chapter 18, “Configuring DHCP
Features”
DHCP snooping information option Enabled
IGMP snooping
IGMP snooping Enabled Chapter 19, “Configuring IGMP Snooping
and MVR”
IGMP filters None applied
IGMP throttling Deny
MVR Disabled
Port-based Traffic
Broadcast, multicast, and unicast storm
control
Disabled Chapter 20, “Configuring Port-Based
Traffic Control”
Protected ports None defined
Unicast and multicast traffic flooding Not blocked
Secure ports None configured
CDP Enabled Chapter 21, “Configuring CDP”
UDLD Disabled Chapter 22, “Configuring UDLD”
SPAN and RSPAN Disabled Chapter 23, “Configuring SPAN and
RSPAN”
Table 1-1 Default Settings After Initial Switch Configuration (continued)
Feature Default Setting More information in...
To Next Page
Loading...
Need help?
General