Citrix ADC MPX
Ports/Transceivers 10G transceiver 1G fiber transceiver 1G copper transceiver
10G port Supported Supported with
exceptions (see note)
Supported
1G fiber port Not Supported Supported Not Supported
1G copper port Not Supported Not Supported Supported
Note:
The following appliances do not support the 1G fiber transceiver in a 10G port.
• MPX/SDX 89xx
• MPX/SDX 89xxT
• MPX/SDX 15xxx‑50G
• MPX/SDX 14xxx‑40G
• MPX/SDX 14xxx‑40S
• MPX/SDX 25xxx‑40G
Workaround: Use a 10G/1G dual speed transceiver to obtain 1G speeds.
For more information about supported transceivers per port, see 25G, 40G, 50G, and 100G ports.
Ports
• What is QSFP+?
QSFP+ stands for Quad Small Form‑factor Pluggable, which is a small, hot‑pluggable transceiver
for connecting data devices. This transceiver is used for 40G interfaces.
QSFP+ to four SFP+ Copper Breakout Cables: These cables connect to four SFP+ 10GE ports
of an ADC appliance on one end and to a QSFP+ 40G port of a Cisco switch on the other end.
Support for 40G connectivity: Citrix ADC models that have at least four 10G SFP+ ports con‑
nect to Cisco 40G interfaces by aggregating four of the 10G SFP+ ports to form a 40G link aggrega‑
tion channel. QSFP to Four port SFP+ Copper Breakout Cable QSFP‑4SFP10G‑CU3M (reports
as L45593‑D178‑C30) is used. The reverse is not supported. That is, connectivity from a 40G
port on a Citrix ADC appliance and 4x10G ports on the peer switch is not supported.
• Which Citrix ADC appliances support the
QSFP‑4SFP10G‑CU3M (reports as L45593‑D178‑C30) Breakout Cable?
Citrix ADC appliances that have at least four 10G SFP+ ports support the QSFP Breakout Cable.
• What is QSFP28?
© 1999–2023 Cloud Soware Group, Inc. All rights reserved. 220
To Next Page
Loading...
Need help?
General
