ARES 506-606 - 02.2005 - GB
L.16
ENGINE OIL: REPLACE
- Run the engine at a speed of 1200 rpm until it reaches its
normal operating temperature.
- Stop the engine.
- Place a suitable recipient under cap (V) ; Connection (W) for
tractors equipped with pneumatic braking.
- Unscrew drain plug or connection (W).
- While the oil is draining out, change the filter cartridges (see
following operation).
- Once the oil has poured out, replace plug (V) or
connection (W).
DIESEL FUEL FILTER CARTRIDGES:
REPLACE
1 - Filter position range ARES 500.
2 - Filter position range ARES 600.
PRE-FILTER
- Loosen the holding ring (A).
- Remove the pre-filter (B).
- Take the holding ring (C) and the decantation bowl (D) and
place them on the new filter.
- Replace the old filter with a new one.
- Tighten the holding ring (A) until it is locked.
FILTER
- Loosen holding ring (E) and remove filter (F).
- Replace the old filter with a new one.
- Tighten the holding ring (E) until it is locked.
- Drain (see chapter "D").
Note: The holding ring is in the correct position when no
further resistance is felt during tightening.
111msn02
111msn03
161msn07
161msn05
Operation n°
29
The oil is hot! Avoid getting burned!.
Operation n°
30
V
W
A
1
B
D
C
E
F
E
2
A
F
B
C
D