Claas ARES 656 - BELTS: CHECK - CHANGE

ARES 506-606 - 02.2005 - GB
L.18
BELTS: CHECK - CHANGE
CHECK
- Inspect the moulded end pieces (G) and (H) on the belt
tensioner (I).
- If end stop (G) of the pivoting tensioner arm hits the fixed end
stop (H), check the state of the different belt pulleys. If the
pulleys seem normal, replace the belt.
REPLACEMENT
- Release the belt tension using a wrench on pulley (J).
- Remove the old belt from the pulleys.
- Slip the new belt between fan (K) and the cooling nozzle (L).
- Assemble the new belt taking care to follow the correct path
over the different pulleys (see "Positioning the belt").
- Tighten the belt with the tensioner (J). Remove the wrench.
POSITION OF BELT
1 - Alternator.
2 - Tensioner roller.
3-Water pump.
4 - Crankshaft.
5 - Cooling compressor.
6 - Return roller.
7 - Fan pulley.
8 - Pneumatic braking compressor:
A - ARES 500 Range.
B - ARES 600 Range.
251hsn01
251hsn02
251msn01
251msn02
Operation n° 32
H
G
I
J
K
L
5 8 8ou 5
6
A
1 7
2
3
4
8
5
B
6
5 8ou
1 7
2
3
4