ARES 506-606 - 02.2005 - GB
G.9
ACTIVE SLIP MANAGEMENT
(TCE 25)
ACTIVE WHEEL SLIP MANAGEMENT DISPLAY
- Press key 10 for active wheel slip management.
- As soon as the function is selected, the corresponding symbol
appears on display (4).
- The Electronic Tracto Control will automatically measure the
average wheel slip and set the wheel slip limit itself. If the
average permitted wheel slip value is ever exceeded, the
linkage is immediately raised so that the tractor can cross the
wet area and avoid becoming bogged down.
Note: The load transfer caused by lifting the implement
allows the tractor to find the necessary grip to get itself out
when bogged down. However, if wheel slip rate is above
65%, the implement is immediately lifted clear to avoid all
risk of getting bogged down.
An arrow appears above the symbol each time the
wheel slip management operates (when the average permitted
wheel slip value is exceeded).
SNAPSHOT DISPLAY OF RATE OF WHEEL SLIP
- A snapshot of the rate of wheel slip appears on screen (4)
when key (11) is pressed. As soon as the function is selected,
the symbol appears.
- To return to position display, press key (11) again.
382hsn16
382hsn17
382hsn18
To Next Page
Loading...
