ARES 506-606 - 02.2005 - GB
G.8
EXTERNAL CONTROL BUTTONS
Positioned on each rear wing, these two push buttons allow the
arms to be raised or lowered for implement hitching and
adjustment operations.
- When a button is pressed, there is a movement of about
10 cm in the required direction.
- To obtain a greater movement, the control has to be released
and pressed again.
Important: Using the external controls puts the box into
safety mode. The safety warning light (5) comes on. To
unlock this safety measure, refer to the paragraph
"Conditions for linkage implementation".
TRANSPORT DAMPER
- To improve driving comfort with heavy implements, the driver
can activate the transport damper. All the swinging
movements caused by the weight of the rear carried
implement are absorbed by the linkage.
- To obtain the damper function, adjust the selector (1) on the
high position (I) and press key (6). Warning light (5) comes on.
- To deactivate the damper function press key (6).
Without the damper (B).
With the damper (C).
382hsn12
382hsn13
382hsn14
382hsn15
During hitching operations or when using the
external linkage control, the operator must
remain outside the hitch frame.
Activate this function when on the road to
maintain good front wheel grip and keep good
steering efficiency.
A
B
C
To Next Page
Loading...
